aquatherm, as a supplier of a complete system, offers all necessary components for the optimum control of a wall and ceiling heating. This counts to new or old buildings, to the connection of still existing heating systems as well as for small surfaces or large objects.

The individual room control for wall and ceiling heating is compellingly pre-scribed acc. to EnEV, provided that the object is completely heated by it.

If the basic load is covered, the individual room control can be done without.

The following control components stand for selection:

1. control by return temperature limiter

for small additional heating surfaces

one circuit (design in cabinet for concealed installation)

2. control for larger heating surfaces

connection via heating circuit manifold

individual room control by means of actuator and room thermostat

3. control for larger heating surfaces

connection via heating circuit manifold

Division of heating groups by means of Tichelmann (reverse return)

distribution technique

aquatherm®- control technique

The control technique for the aquatherm-climasystem is identical to our aquatherm®-under-floor heating.

Wired controls with 230 volt and 24 volt, just as the wireless controls are used. The technical description of the control components is to infer in the technical brochure “aquatherm®-Flächenheizsysteme“, heating system”, chapter “Automatic Control” (order-no. E 90000).

Never mount aquatherm-room thermostats behind curtains, in draught, or direct to solar radiation.

Also they must not be placed directly on the heated surfaces.

1) Flow

2) Return

3) aquatherm®-heating circuit manifold

4) Wall-heating zone 1

with aquatherm-climasystem for individual connection (max. 15 m2)

5) Wall-heating zone 2

with aquatherm-climasystem for individual connection (max. 15 m2)

1) Flow

2) Return

3) aquatherm®-heating circuit manifold

4) Wall-heating zone (max. 10,0 m2)

5) Heating circuit for additional heating zones

1) Flow heating

2) Return heating

3) Static heating surface

4) The aquatherm-climasystem (max. 8 m2)

5) Flow heating grid

6) Return heating grid

7) aquatherm-return temperature limiter (Art.-No. 94161)

Heating:

In wintertime they are always utilized:

The aquatherm-heating systems for ceiling, wall and floor.

The are installed in private homes, apartments, business buildings, hotels, hospitals, offices, schools, etc. But unfortunately, during the summer months these expensive heating systems are unused.

With the control statement “heating and cooling” the needs “heating and cooling” blend into a single arrangement. Based on climate control with change-over “heating/cooling” a complete control system including all requirements is available.

The control system described below, contains the energy saving features as well as the optimised cooling functions.

Cooling:

Special care is required to the dew point concerning the space cooling.

The principle pattern takes into consideration the dew point, so that there is no condensation produced.

Principle pattern of a double-pipe arrangement

(Suppliers: e.g. Sauter-Cumulus, Freiburg; Company Siemens, etc.)